EBC brake disc for off-road motorcycles. MADE IN THE UK.

The aim of the development is to improve the braking behavior compared to the original brake disc. EBC uses heat-treated carbon steel for the brake discs of off-road motorcycles, which are primarily ridden off-road. This steel is much more resistant to rust than cast steel. In addition, the entire surface is protected with a 3 micron thick layer of zinc, which is crushed in the area of the contact patch of the brake pads when braking. It is only in this area that a light oxide film with a longer service life can form.

The brake discs are drilled in the bird's-eye design to fit through with as few holes as possible and at the same time the cleaning of the brake disc from rainwater and brake dust is optimized. The fewer holes drilled, the better the wet braking behavior and less wear.

- Rigid brake disc.

- Made of heat-treated carbon steel.

- Drilled braking surface with optimized hole pattern.

- Radially ground.

- Galvanized to protect against corrosion.

- Independent design.

- The thickness of the brake disc may vary compared to the original part.
OUTSIDE DIAMETER: 220MM
INSIDE DIAMETER: 102.2MM
CIRCLE SIZE: 120 MM
HOLES QUANTITY: 5
HOLE DIAMETER: 8.5 MM
THICKNESS: 4.5MM
VERSION: RIGID


APPLICATIONS OF THIS PRODUCT:
According to the data provided by the manufacturer, this article is compatible with the following brands, models and years:
MBK XQ 125 THUNDER 11,8 CV, 8,7 KW 1CIL. SE052 5HT2 BASTIDORES: SE052000 henceforth00110-- 2001-2003
YAMAHA XQ 125 MAXSTER 11,8 CV, 8,7 KW 1CIL. SE051 5HT1 BASTIDORES: SE051 henceforth00101-SE051 henceforth05463 2001-2003
YAMAHA XQ 150 MAXSTER 13 CV, 9,6 KW 1CIL. SG061 5LG1 BASTIDORES: SG061 henceforth00101-SG061 henceforth01314 2001-2002