MOTUL Synthetic motor oil for motorcycle 300V FL ROAD RACING 5W-40 1L 300V FL ROAD RACING 5W-40 1L 714.05.26

Motul 300V Factory Line Road Racing 5W-40



MOTUL 300V POWER is an all-season racing engine oil based on E-technology with high HTHS viscosity. Developed for competition engines, which are used in a wide range of speeds and temperatures. Especially suitable for rallies, GT and short distance races.



SPECIFICATIONS/STANDARDS:

STANDARDS: Exceeds existing motorsport standards

USE: Rally, GT, short distance racing



ESTERS TECHNOLOGY:

MOTUL has been developing high-performance motor oils based on synthetic esters for several decades. The special selection of synthetic esters and the combination with an innovative additive package form an extraordinary synergy. ESTER Core is the latest stage of technological development and allows maximum engine power to be obtained without compromising reliability and wear.



Advantages

-Max. Oil film stability, optimal adhesion, high temperature resistance for optimal wear protection.

- Very good cold start properties. Optimum engine lubrication even at very low temperatures.

- Special friction modifiers allow a significant reduction of the friction resistance in the engine and a reduction of the operating temperature.

- The high pressure absorption capacity guarantees maximum lubrication reliability even in extreme temperature ranges.

- The ester base reduces the operating temperature up to 10°C in the upper ranges and has very good adhesion to metal surfaces.

- The low viscosity SAE 5W-40 allows a very fast build-up of the oil film, it has a performance-enhancing effect.

- Minimal tendency to evaporation, so oil consumption is low.

- Extremely resistant to shearing, stable oil pressure in all operating conditions.



RECOMMENDATIONS:

Due to the 5W-40 viscosity, only a small amount of unburned fuel can be made up. Miscible with mineral and synthetic motor oils. However, for optimum engine performance, mixing with other mineral and synthetic motor oils should be avoided. Oil change interval: depending on the type of use and operating conditions.



Properties:

Viscosity SAE J 300 5W-40

Density at 20°C ASTM D 1298 0.860

Viscosity at 100°C ASTM D 445 13.6 mm²/s

Viscosity at 40°C ASTM D 445 81.8 mm²/s

Viscosity index ASTM D 2270 174

HTHS Viscosity ASTM D 4741 4.1 mPa*s

Pour point ASTM D 97 -45°C

Flash point ASTM D 92 230°C

TBN ASTM D 2896 8.25 mg KOH/g
APPLICATION: ENGINE
VISCOSITY: 5W40
TYPE: 4-STROKE
QUALITY: SYNTHETIC
CONTENT: 1 LITERS