EBC HPSR brake disc, rigid version. MADE IN THE UK.

The aim of the development is to improve the braking behavior compared to the original brake disc. EBC uses low carbon HPSR steel, which has an 18% higher coefficient of friction. This steel is much more resistant to rust than cast steel. In addition, the entire surface is protected with a 3 micron thick layer of zinc, which is rubbed into the area of the contact patch of the brake pads when braking. Only in this area can a light oxide film form after a long period of time.

The brake discs are drilled in the shape of a bird's wing to work with as few holes as possible and at the same time optimized cleaning of the brake disc from rainwater and brake dust. The fewer holes there are, the better wet braking behavior and less wear.

- Brake ring milled in forged HPSR steel with low carbon content.

- Therefore, there is no distortion of the brake disc even under the highest load.

- No glazing of the braking surface, so the coefficient of friction remains constant.

- Braking surface drilled with an optimized hole pattern.

- Galvanized to protect against corrosion.

- Lower manufacturing tolerances.

- EBC recommends EBC Double-H sintered brake pads for the best braking performance.

- Independent design.
OUTER DIAMETER: 155MM
INSIDE DIAMETER: 42.2MM
CIRCLE SIZE: 58 MM
QUANTITY OF HOLES: 3
HOLE DIAMETER: 8.5 MM
thickness: 3mm
VERSION: RIGID


APPLICATIONS OF THIS PRODUCT:
According to the data provided by the manufacturer, this article is compatible with the following brands, models and years:
PEUGEOT LUDIX 50 II SNAKE NAKED 10 PULGADAS 3,9 CV, 2,9 KW 1CIL. - BASTIDORES: --- 2008-2011
PEUGEOT LUDIX 50 SNAKE 4,4 CV, 3,2 KW 1CIL. VGA L1AAACA/FA BASTIDORES: --- 2004-2007
PEUGEOT LUDIX 50 TREND 10 PULGADAS 4,4 CV, 3,2 KW 1CIL. VGA L1AAAAA BASTIDORES: --- 2004-2007