The aim of development is to improve braking performance compared to the original brake disc. EBC uses heat-treated carbon steel for the MX Contour brake rotors. This steel is much more resistant to rust than cast steel.
In addition, the entire surface is protected with a 3 micron thick layer of zinc, which wears off in the contact zone of the brake pads already during braking.
Only in this area can slight oxidation form after a long period of use.
The brake discs are drilled in a birdcage pattern to achieve as few holes as possible while optimizing the cleaning of the brake disc from rainwater and brake dust. The fewer holes there are, the better the performance of the brakes in the wet and the less wear.
- Cutting-edge contour design
- Super-light, rigid brake disc, completely new profile.
- Made of carbon steel with heat treatment.
- Braking surface drilled with an optimized hole pattern.
- Radially ground.
- Galvanized to protect it from corrosion.
- Independent design.
- The thickness of the brake disc may vary compared to the original part.
MADE IN THE UK OUTSIDE DIAMETER: 190MM QUANTITY OF HOLES: 3 VERSION: RIGID