Universal spatula for emergency repairs, resistant to oil, water, most common chemicals and high temperatures
Suitable for the following repairs: Gas tanks, refrigerators, concrete, Housing and castings and many others
Suitable for the following surfaces: steel, aluminium, galvanized steel, fiberglass, copper and tin
The mixture (component A + B)
Mixing ratio 100: 2-3
dripping time (20 °C, 50% RH) 4.5 min.
Sanding properties after 15 to 20 min.
preparation
The spachtelnde to substrate must be free of grease, clean and dry
In this rust has to be removed and then the corresponding
sanding repair area with 120 grit sandpaper
The paint around the repair site does not have to be removed once the existing paint has good adhesion.
The repair area is recommended to be cleaned before the next operation with TEROSON VR 20 and pretreated.
Prosecution
The filler in the volume ratio (polyester resin to TEROSON UP 190 hardener) Golf ball size (40 ml) to pea size 4 to 5 cm (2 to 3%) of the mixture until it is achieves a homogeneously mixed mass
After mixing, the drip time is approximately 4.5 minutes at 20°C.
Filler mixture is so, it is applied to the repair area that dent, scratches or surface irregularities are completed
high coating thickness must be configured to avoid cracking in several operations
The putty is sanded at room temperature after 15 to 20 minutes. accelerated curing by heat is 10 minutes after the work is possible (at a maximum of 60 ° C by IR lamps or in an oven)