High Tech Rust Converter in the standard bottle fits all underbody guard and cavity guns available on the market
1000 ml enough for approx. 12 - 15 m² (with brush)
In the printing process sufficient for cavity treatment of small cavities, such as A-pillars, hoods, etc.
Atomizes and removes rust sustainably.
Remove rust without sandblasting
Harmless to plastic, rubber, chrome and paint.
For over two decades a proven rust and corrosion removal product.
It can be used successfully on strong rust, lightly oxidized, and bare metal as well. The protective effect is basically achieved
Built for reasons of environmental protection on the basis of water. Therefore, the area to be treated must be free of dirt, oil, grease and silicone, i.e. clean, but not rust-proof.
Only with extremely strong oxide layers, greater than 5 mm, a second treatment may be necessary.
Apply only at temperatures above 5°C and leave on for approximately 24 - 48 hours.
Always clean the surface with water before finishing.
It can be used even on wet surfaces and is free of contaminants.