EBC brake disc for offroad motorcycles. MADE IN UK.
The aim of the development is to improve the braking performance compared to the original brake disc. EBC uses heat-treated carbon steel for the brake discs of off-road motorcycles that are primarily ridden off-road. This steel is much more resistant to rust than cast steel. In addition, the entire surface is protected by a 3 micron thick layer of zinc, which wears off in the area of the contact patch of the brake pads during braking. Only in this area can rust form more easily during extended life.
The brake discs are drilled in Vogelschwingendesign to get along with as few holes as possible while optimizing the cleaning of the brake disc with rainwater and brake dust. The fewer holes installed, the better wet braking and less wear.
- Hard disk.
- Made of carbon steel with heat treatment.
- perforated brake surface with optimized hole pattern.
- Radially ground.
- Galvanized for protection against corrosion.
- Independent design.
- The thickness of the brake disc may vary compared to the original part. OUTER DIAMETER: 263MM INSIDE DIAMETER: 101MM CIRCLE SIZE: 120 MM HOLES QUANTITY: 5 HOLE DIAMETER: 8.5 MM thickness: 5mm VERSION: RIGID