EBC MX brake disc for all-terrain motorcycles. MADE IN THE UK.
The aim of the development is to improve the braking behavior compared to the original brake disc. EBC uses low carbon HPSR steel, which has an 18% higher coefficient of friction. This steel is much more resistant to rust than cast steel. In addition, the entire surface is protected with a 3 micron thick layer of zinc, which is rubbed into the area of the contact patch of the brake pads when braking. Only in this area can a slight flash of rust form after a long period of time.
The brake discs are drilled in a bird's wing design to function with as few holes as possible and at the same time optimized cleaning of the brake disc from rainwater and brake dust. The fewer holes there are, the better braking behavior in the wet and less wear.
- Rigid brake disc.
- Made of heat-treated carbon steel.
- Braking surface drilled with an optimized hole pattern.
- Radially ground.
- Galvanized to protect against corrosion.
- EBC recommends EBC Organic TT brake pads or for sports drivers EBC sintered brake pads in R or MXS mix.
- Independent design.
- The thickness of the brake disc may vary with respect to the original part. OUTSIDE DIAMETER: 220MM INSIDE DIAMETER: 115.2MM CIRCLE SIZE: 133 MM HOLES QUANTITY: 6 HOLE DIAMETER: 6.5 MM THICKNESS: 4.5MM VERSION: RIGID