RFX front wheel spacers PRO 1123313003VAR

RFX Pro Series Wheel Spacers are lighter and more durable than OEM.

Constructed from 7075-T6 aluminum and color anodized to increase durability. This helps reduce surface wear and decreases the amount of dirt entering the hub, which in turn extends the life of the bearing.

Designed with a rear lip to help keep them engaged in the seals, this reduces the chance of them falling off during maintenance, speeding up wheel changes.

RFX products are tested and used by many of the top British Grand Prix and Motocross teams.

Aluminum construction 7075-T6.

Color anodized for durability.

Machined rear locating lip.

CNC machining:

For a tighter tolerance

Assembly instructions:

Start with the motorcycle on a box stand with the wheels off the ground.

Remove the large spindle nut and loosen the lower fork leg retaining bolts.

Remove the wheel axle, this may require the use of a brass punch and hammer if it is tight.

The front wheel will now be removed.

The rear wheel should now be slack enough to push forward and lift the chain off the rear sprocket.

The rear wheel will now be removed.

Remove the wheel spacers from the wheels.

Clean in and around the seals with a contact cleaner such as Maxima Electrical Contact and re-grease under the seal.

Fit the new wheel spacers.

Be sure to open the brake pads inside the brake calipers to give yourself more room when you remount the wheel.

Reattach the wheels and push the axles.

Replace the chain and set the proper chain tension by adjusting the axle blocks.

Tighten the large spindle nuts to the correct torque.

With the bike on the stand, pump the front forks up and down to align the front forks and then tighten the retaining bolts.

Finally, pump the brakes to realign the calipers.
COMPOSITION: ALUMINUM
COMPOSITION: ALUMINUM