HIGHSIDER flasher relay CAN-BUS CBW1 1107933

CAN-BUS HIGHSIDER CBW1 resistor with DIP switches. Our new HIGHSIDER CBW1 CAN-BUS resistor is suitable for most vehicles equipped with a CAN-BUS system. The CBW1 resistor provides a necessary electrical load for your vehicle which, if the DIP switches are set correctly, does not cause an error message in the cockpit when the accessory indicators are used.

It also ensures trouble-free operation. That means:

If the accessory indicators fail due to an electronic fault, an error message is immediately displayed in the cockpit.

If 2 pairs of turn signals (VL,VR,HL,HR) need to be replaced, 2 x CBW1 can be used, such as rear left and rear right turn signals.

What requirements must be met to use the CBW1 on the vehicle:

E Either:

LED indicators have been installed on the vehicle in their original condition.

Gold:

Or:

The vehicle is equipped with a CAN-BUS system.

If none of these requirements are met, the CBW1 cannot be installed (!).), we recommend the following resistors for the vehicle:

F for 21 Watt indicators

Part number of 6.8 ohms 207-025

GOLD

10 ohms part number 207-028

F for 10 Watt lights

27 ohms part number 207-020

The following values can be set:

150 Ohms

170 Ohms

200 Ohms

240 Ohms

300 Ohms

400 Ohms

600 Ohms

1200 ohms

measures :

Height = 11mm

Width = 31 mm (without legs)

Width = 46 mm (with legs)

Length = 40mm

Cable length = 200 mm with pins

connection:

Yellow = Intake duct 1 (+)

Orange = Exhaust pipe 1 (+)

Blue = Intake Channel 2 (+)

Red = Exhaust Pipe 2 (+)

Gray = Input Ground (-)

Black = Output Ground (-)
ANCHURA (MM): 40
LONGITUD (MM): 46
PACKAGING: PER UNIT
PACKAGING: PER UNIT
RANGE: HIGHSIDER SMART